Top 10 Which Is The Start Capacitor On A Ao Smith Motor

Dimensions ref. (1) C = 20-1/8″, BM = 3-5/8″, N1 = 5-3/8″, N = 5-3/8″. This is an aftermarket replacement motor. Be sure to review the specs and dimensions to your motor to verify it will work. This has also been used for 6757A313, 6757A311, K55HXJCP-2593, 322P708

A capacitor is an electric component that temporarily stores an electrical charge. A “run capacitor” supports electric motors, such as in air conditioner or heat pump units, a fan motor and a compressor motor. The capacitor has two terminals.
Capacitors come in a variety of sizes, depending on the capacitance (µF or MFD), such as 40 plus 5 µF, and also the voltage. A 440 volt capacitor can be used in place of a 370 volt, as it is build better, but the 370 can’t be used in place of a 440 volt. It will work for a while and will fail prematurely, as exceeding the capacitor’s rated voltage will cause the dielectric to break down and the capacitor to short out. Same as an electric wire- 600V rated wire is better than 300V one .The capacitance(µF or MFD) must be the same or stay within 10%+ or 5%- of its original value . Example: 50 µF cap can be substituted by 47.5 to 55 µF with the same or better voltage ratings capacitor . Round oval-shaped run capacitors are commonly used for air conditioning, to help in the starting of the compressor and the condenser fan motor.
You will ask “Why I need a Cap that is rated 440V in my A/C?”
Answer: You need to realize that a motor is an inductive device. When the supply voltage is applied to the motor run winding, the voltage across the start winding will be increased to a higher voltage value. A motor acts like a transformer with the run winding acting as the primary and the start winding acting as the secondary. This is why the capacitor has a much higher voltage rating than the 230 being the supply voltage.
If a Capacitor is not EIA-456-A approved means it is not approved for US market.

A capacitor is an electric component that temporarily stores an electrical charge. A dual “run capacitor” supports two electric motors, such as in large air conditioner or heat pump units, with both a fan motor and a compressor motor. It saves space by combining two physical capacitors into one case. The dual capacitor has three terminals labeled “C”, “FAN”, and “HERM”, which stand for the *C*ommon, Fan, and *HERM*etically sealed compressor.

Dual capacitors come in a variety of sizes, depending on the capacitance (µF or MFD), such as 40 plus 5 µF, and also the voltage. A 440 volt capacitor can be used in place of a 370 volt, as it is build better, but the 370 can’t be used in place of a 440 volt. It will work for a while and will fail prematurely, as exceeding the capacitor’s rated voltage will cause the dielectric to break down and the capacitor to short out. Same as an electric wire- 600V rated wire is better than 300V one .The capacitance(µF or MFD) must be the same or stay within 10%+ or 5%- of its original value . Example: 50 µF cap can be substituted by 47.5 to 55 µF with the same or better voltage ratings capacitor .

Round cylinder-shaped dual run capacitors are commonly used for air conditioning, to help in the starting of the compressor and the condenser fan motor.Round capacitor can be used to substitute oval shape one with the same MFD AND Volt specs

GE Genteq Capacitor round 55/5 uf MFD 440 volt 97F9839 (replaces old GE# 97Z9839BZ3, Z97F9839, & 97F9839BX, CPT00670, P2915554RS), 55 + 5 MFD at 440 volts

High quality and long life.
Nominal Capacitance : 0.1uF~1000uF
Capacitance Tolerance: electrolytic +/-20%
Operating Temperature Range: -40deg/C ~105+deg/C
Temperature Coefficient: -55to+175deg C
Package list:
0.1uF 50V 4×7 30pcs
0.22uF 50V 5×11 20pcs
0.47uF 50V 5×11 20pcs
1uF 50V 5×11 20pcs
2.2uF 50V 4×7 30pcs
3.3uF 50V 4×7 30pcs
4.7uF 50V 4×7 30pcs
10uF 25V 4×7 30pcs
10uF 50V 5×11 20pcs
22uF 16V 4×7 30pcs
22uF 25V 4×7 30pcs
33uF 16V 4×7 30pcs
47uF 10V 4×7 30pcs
47uF 25V 5×11 20pcs
47uF 50V 6×11 15pcs
100uF 16V 5×11 20pcs
100uF 25V 5×11 15pcs
220uF 10V 5×11 15pcs
220uF 25V 6×11 15pcs
330uF 25V 8×12 10pcs
470uF 10V 6×11 10pcs
470uF 16V 8×12 10pcs
680uF 16V 8×12 10pcs
1000uF 16V 10×16 10pcs
Note: the order of random assembly, packaging does not contain the card, do not mind please orders

A capacitor is an electric component that temporarily stores an electrical charge. A dual “run capacitor” supports two electric motors, such as a fan motor and a compressor. Round dual run capacitors are used to start and run the unit more efficient. It saves space by combining two physical capacitors into one case. The dual capacitor has three terminals labeled “C”, “FAN”, and “HERM”, which stand for the *C*ommon, Fan, and *HERM*etically sealed compressor.

Dual capacitors come in a variety of sizes, depending on the capacitance (µF = MFD = micro farad), such as 60 plus 5 µF, and also the voltage. A 440 volt capacitor can be used in place of a 370 volt, as it is build better, but the 370 can’t be used in place of a 440 volt. It will work for a while and will fail prematurely, as exceeding the capacitor’s rated voltage will cause the dielectric to break down and the capacitor to short out. Same as an electric wire- 600V rated wire is better than 300V one .The capacitance(µF or MFD or micro farad) must be the same or stay within 10%+ or 5%- of its original value . Example: 60 µF cap can be substituted by 57 – 66 MFD with the same or better voltage ratings capacitor.

If your fan is working but compressor not, or the capacitor is bulged on top most likely your capacitor is defective. Round capacitor can be used to substitute oval shape one with the same MFD AND Volt specs.

You will ask “Why I need a Cap that is rated 440V in my A/C?”

Answer: You need to realize that a motor is an inductive device. When the supply voltage is applied to the motor run winding, the voltage across the start winding will be increased to a higher voltage value. A motor acts like a transformer with the run winding acting as the primary and the start winding acting as the secondary. This is why the capacitor has a much higher voltage rating than the 230 being the supply voltage.

If a Capacitor is not EIA-456-A approved means it is NOT approved for USA market.

A capacitor is an electric component that temporarily stores an electrical charge. A dual “run capacitor” supports two electric motors, such as a fan motor and a compressor. Round dual run capacitors are used to start and run the unit more efficient. It saves space by combining two physical capacitors into one case. The dual capacitor has three terminals labeled “C”, “FAN”, and “HERM”, which stand for the *C*ommon, Fan, and *HERM*etically sealed compressor.

Dual capacitors come in a variety of sizes, depending on the capacitance (µF = MFD = micro farad), such as 60 plus 5 µF, and also the voltage. A 440 volt capacitor can be used in place of a 370 volt, as it is build better, but the 370 can’t be used in place of a 440 volt. It will work for a while and will fail prematurely, as exceeding the capacitor’s rated voltage will cause the dielectric to break down and the capacitor to short out. Same as an electric wire- 600V rated wire is better than 300V one .The capacitance(µF or MFD or micro farad) must be the same or stay within 10%+ or 5%- of its original value . Example: 35 µF cap can be substituted by 33 – 38 MFD with the same or better voltage ratings capacitor.

If your fan is working but compressor not, or the capacitor is bulged on top most likely your capacitor is defective. Round capacitor can be used to substitute oval shape one with the same MFD AND Volt specs.

You will ask “Why I need a Cap that is rated 440V in my A/C?”

Answer: You need to realize that a motor is an inductive device. When the supply voltage is applied to the motor run winding, the voltage across the start winding will be increased to a higher voltage value. A motor acts like a transformer with the run winding acting as the primary and the start winding acting as the secondary. This is why the capacitor has a much higher voltage rating than the 230 being the supply voltage.

If a Capacitor is not EIA-456-A approved means it is NOT approved for USA market.

Our Promise to Readers

We keep receiving tons of questions of readers who are going to buy Which Is The Start Capacitor On A Ao Smith Motor, eg:

• What are Top 10 Which Is The Start Capacitor On A Ao Smith Motor for 2020, for 2019, for 2018 or even 2017 (old models)?
• What is Top 10 Which Is The Start Capacitor On A Ao Smith Motor to buy?
• What are Top Rated Which Is The Start Capacitor On A Ao Smith Motor to buy on the market?
• or even What is Top 10 affordable (best budget, best cheap or even best expensive!!!) Which Is The Start Capacitor On A Ao Smith Motor?…
• All of these above questions make you crazy whenever coming up with them. We know your feelings because we used to be in this weird situation when searching for Which Is The Start Capacitor On A Ao Smith Motor.
• Before deciding to buy any Which Is The Start Capacitor On A Ao Smith Motor, make sure you research and read carefully the buying guide somewhere else from trusted sources. We will not repeat it here to save your time.
• You will know how you should choose Which Is The Start Capacitor On A Ao Smith Motor and What you should consider when buying the Which Is The Start Capacitor On A Ao Smith Motor and Where to Buy or Purchase the Which Is The Start Capacitor On A Ao Smith Motor. Just consider our rankings above as a suggestion. The final choice is yours.
• That’s why we use Big Data and AI to solve the issue. We use our own invented, special algorithms to generate lists of Top 10 brands and give them our own Scores to rank them from 1st to 10th.
• You could see the top 10 Which Is The Start Capacitor On A Ao Smith Motor of 2020 above. The lists of best products are updated regularly, so you can be sure that the information provided is up-to-date.
• You may read more about us to know what we have achieved so far. Don’t hesitate to contact us if something’s wrong or mislead information about Which Is The Start Capacitor On A Ao Smith Motor.